Certified Re-manufactured Process
The difference between "USED" and "REMANUFACTURED" fitness equipment is gigantic. Used machines look and feel like old units. Certified-Remanufactured machines on the other hand, look and work LIKE-NEW.
Our selection of CERTIFIED-REMANUFACTURED equipment offers health club quality machines at deeply discounted prices. Below is our remanufacturing process for making your machine LIKE-NEW. This is done in-house, giving us complete knowledge of each machine and you a WAREHOUSE DIRECT SALE price.
PHASE 1: TAKE THE MACHINE APART

After disassembling the entire machine, we inspect and clean all parts, to make sure none are missing, or broken.
PHASE 2: ELECTRONICS BENCH TESTING

Once the machine has been taken apart and cleaned, we inspect the electronics, control board (display panel) and keypad switches. Our technicians test the speed and incline buttons, to confirm they respond with speed and accuracy. Then we test the Heart-Rate monitor to make sure its readouts are correct and replace the HR hand-grips if necessary. Next up, we perform a full diagnosis of the the workout programs, confirming they run properly. Finally, power cords are then inspected and switched out if necessary.
PHASE 3: PART REPLACEMENT

All mechanical parts with too much "wear and tear" are replaced. All batteries, all walking belts (except on Woodway Treadmills) and all drive-belts are replaced on our cardio machines. For our strength equipment, we replace the cables, pulleys, chains and other hardware if necessary.
PHASE 4: EXTERIOR RESTORATION

Certified technicians sandblast the machine down to its frame, then powder-coat, or paint the machine with its original factory color. This process makes older machines look like new, through removing rust, scratches and other blemishes.
PHASE 5: REBUILDING THE MACHINE

We assemble the machine back to its original design, while confirming the structural integrity and bio-mechanics match factory specifications.
PHASE 6: CHECK FOR NOISE

We test each machine to make sure there aren't any irregular noises such as grinding or squeaking. We use industrial quality lubricants and waxes to make sure your machine operates smoothly.
FINAL EXAMINATION

This is a final 10 minute overview of the machine by our warehouse manager. With final approval, your equipment gets packaged and ready for shipping.
